2017
-
Mejora de cajas en Nucor Steel Carolina del Sur
Located in Darlington, SC, Nucor Steel South Carolina has replaced thirteen stand drives of its bar mill number 2. Russula provided the electrical equipment and engineering and on-site services of installation, supervision and commissioning.
Scope of Supply
The existing rolling mill stand drives, type SD3000, are installed in line-ups consisting of a drive and an AC incoming circuit breaker. The objective of the upgrade was to replace the existing power and controls of the drives and AC breakers for 12 mill stands. Each drive was replaced with a new equivalent unit based on the ABB DCS800 series. The new drives were supplied already installed in cabinets and were integrated into the control system using ethernet.
Results
In order to minimize disruptions to operations thirteen drives were pre-installed along side the existing drives to effectively switch over during the commissioning period that began on September 24th, 2017. The new drives were successfully commissioned during the seven-day outage and NSSC resumed production on October 1st, 2017.
About Nucor Steel South Carolina
Nucor Steel South Carolina produces special bar quality and merchant bar quality, angles, channels, flats, rounds, round cornered squares, round coils, hexagons, and wire rod in more than 750 grades of steel. Since beginning operations in 1969 as Nucor Corporation’s first bar mill, NSSC has grown to become the largest bar producer in the Southeast.
